EEPROM 95160 PDF

STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Faelar Arajin
Country: Guinea-Bissau
Language: English (Spanish)
Genre: Health and Food
Published (Last): 23 August 2006
Pages: 393
PDF File Size: 4.7 Mb
ePub File Size: 10.76 Mb
ISBN: 637-3-86368-186-3
Downloads: 74425
Price: Free* [*Free Regsitration Required]
Uploader: Dukazahn

Reply 15 ZLM Posts. Reply 8 benaknoun Spain Posts.

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

I think it should be SOIC8 mil chip. Reply 17 ZLM Posts. Reply 1 ZLM Posts. Reply 3 ZLM Posts. Use ToolA instead, because your chip pins already damaged. Reply 10 benaknoun Spain Posts.

But the fast way is to remove it from board and program it on the programmer ZIF spcket directly. Reply 12 ZLM Posts. Reply 14 benaknoun Spain Posts.

TOP Related Posts  DESVAIRADA PARTITURA PDF

Also, when i click on ID, it says “function not supported on this device” Image Insert: 9560 13 benaknoun Spain Posts.

You need to find a way to test the data. So, if you can not read anything out, make sure your pins have good contacting. Reply 2 benaknoun Spain Posts.

MCUmall EPROM BIOS Chip Burner Forum – 8pin

It is SOIC8 mil chip. It should be able to open it by same software.

You can save data as. Hi, i have received the tools i bought from mcumall canada, there are numbers on the adapters, how do i know which pin is the right matching one with the chip?

What is exact part number? Device blank check failed at address: What is your another adapter part number? Reply 9 ZLM Posts. If the chip is not designed for programming in circuit, then you need to try to find some connection.

To be honest though, the other adapter i bought, not sure what its for?? Hi, it seems i’m doing something right then! That is safe and fastest way. Try to power up the board and do not connect pin 8 Vcc pin. The only way to test data is: Then 9560 ADP should be used.

TOP Related Posts  HAMSHAHRI NEWSPAPER EPUB

What is your chip on board? Also, another question please about the same chip: The “Device blank check failed ” means the chip is not a blank chip, there are some data in the chip. The wire can be any wires, as long as you can solder it.

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Most of used on-board chips should have something. Reply 6 benaknoun Spain Posts. Reply 7 ZLM Posts. Hi, i have connected the tool to the chip and adapter to the programmer.

Reply 19 ZLM Posts.